Drop protection sleeve
Required DURABASE WS products
Self-adhesive wall sealing set for dry sealing walls and floors.
1 Sealing membrane 1 m x 30 m; 2 Spray primer; 3 Corner adhesive tape 120 mm x 50 m; 4 Plinth sealing tape 50 m;
5 Installation aid: squeegee; 6 2x wall sleeves 1/2″; 7 Drip protection sleeve; 8 Installation instructions.
Sealing membrane
Inside and outside corners
Plinth seal
Corner adhesive tape with trowel protection
Installation instructions for anti-drip collar
1. position the sealing sleeve in the center of the connection.
2. spread the insertion sleeve slightly (detail) and place it on the sealing sleeve.
3 Press the insertion sleeve over the fitting with both thumbs in the direction of the pipe connection.
4 Push the collar of the sealing sleeve over the pipe connection using the insertion sleeve. The sleeve collar must sit on the water connection with tension !
5. remove the insertion sleeve.
6. screw in the construction plug.
7. fold the sealing sleeve towards the center.
8. turn inwards again.
9. wrap the folded sealing sleeve around the side of the building plug.
10 The sealing sleeve is held together by the insertion sleeve.
11. plaster the wall surface.
12. prime the wall surface.
13. remove the insertion sleeve. Unfold the sealing sleeve. Carefully remove any remaining lubricant. The sealing surface of the sealing sleeve must remain absolutely grease-free! Remove the protective film.
14 Press the sealing collar firmly into place with the spatula.
15 Apply the corner adhesive tape to the sealing sleeve and roll it on tightly.
16. cut the sealing sheet horizontally and cut it out at the pipe penetration.
17 Replace the lower part of the sealing strip. Continue with the wall sealing.
