Floor-level shower
Required DURABASE WS products
Self-adhesive wall sealing set for dry sealing walls and floors.
1 Sealing membrane 1 m x 30 m; 2 Spray primer; 3 Corner adhesive tape 120 mm x 50 m; 4 Plinth sealing tape 50 m; 5 Installation aid: squeegee; 6 2x wall sleeves 1/2″; 7 Drip protection sleeve; 8 Installation instructions.
Wedge-shaped corner on floor-level showerwith corner adhesive tape + trowel protection
1. sealing sealing wedge (step 20 or 28 mm)
2. sealing wedge for floor-level showers (corner installation).
3 . installation of the wedge at the transition from wall/shower, wall/floor and shower/floor. To do this, peel off the protective films one at a time in the order 1-3 and stick them in place.
4. attach the inside corners and connect with corner adhesive tape.
5. prime inside corners and sealing wedge on wall/floor with primer spray.
6. preparation and application of the corner adhesive tape: The ends of each of the three corner adhesive tapes must be mitred at the inside corners (see Figures B 1 and B 8). The corner adhesive tapes must not overlap! (Too high installation height!)
7. attaching the corner adhesive tape to the sealing wedge: The corner adhesive tapes must not overlap! (Too high installation height!) Roll on all corner tapes firmly.ee
8. corner adhesive tape on the shower channel: Cut out the inner body with a knife.
9. provide the entire wet area on the wall and floor with sealing sheets.
F 10. Cut out the sealing strip on the inside of the shower channel body with a knife.
