Inside/outside corners and corner tape
Required DURABASE WS products
Self-adhesive wall sealing set for dry sealing walls and floors.
1 Sealing membrane 1 m x 30 m; 2 Spray primer; 3 Corner adhesive tape 120 mm x 50 m; 4 Plinth sealing tape 50 m;
5 Installation aid: squeegee; 6 2x wall sleeves 1/2″; 7 Drip protection sleeve; 8 Installation instructions.
Sealing membrane
Inside and outside corners
Plinth seal
Corner adhesive tape with trowel protection
BSeal the transitions between wall/wall and wall/floor with internal/external corners and with corner adhesive tape.
Attach the self-adhesive inner and outer corners and the corner adhesive tapes.
The inner corners (a) ensure absolute tightness at the intersection of the overlapping corner tapes (b) in the area of the remaining fillet (c) . The flexible PE foam compensates for unevenness.
in the wall and floor area.
2. the inside corner is folded (1-4) and shortened if necessary (see Fig. B 3).
3. self-adhesive inner and outer corners can be shortened to 50 mm all round.
4. push the pyramid in the corner down to approx. 1 cm above the floor, remove the covering foil at the bottom. Slide the pyramid all the way down the wall and press it onto the floor.
5. the 3 edges of the inside corners must fit snugly in the corner of the room! The tip of the inside corner can be shortened if required.
6 . then remove the cover foils from the side panels (2+3) and glue the raised inner corner to the two walls (4).
7. fold the corner adhesive tape (1). Slightly peel off the protective film at the top left ( 2). Lay the corner adhesive tape halves on top of each other, place the fold in the top corner of the room (3) and press down. Press on the left half of the corner adhesive tape with the squeegee (4). Remove the right-hand protective film (5) and press on the corner adhesive tape with the squeegee (6).
8. 1. wet wipe the outer or inner corner. 2. wipe dry. 3a or 3b Bonding the sealing membrane to the outer or inner corner.
9 Attach the corner adhesive tape: The corner adhesive tapes must be beveled at 45° on the inside corners (see Fig. B1). The corner adhesive tapes must not overlap! (Too high installation height!)
10 Example: Attach self-adhesive inner corner in the wall/wall/niche floor corner, shorten beforehand if necessary, see B 5.
11 Example: Attach self-adhesive inner corner in the wall/tub/floor corner. If necessary, the self-adhesive inner corner can be cut to fit.
12. attach the inside corner starting at the top. Peel off the cover film downwards. Apply the corner adhesive tape as shown in Fig. B 7. Press on with a squeegee.
13. all pipe penetrations (e.g. 1/2) are secured with wall sleeves: 1. put the sleeve with membrane over the protective plug 2. remove the cover foil 3. press on the sleeve without bubbles.
14. all pipe penetrations (e.g. DN50) are secured with wall sleeves: 1. put the sleeve with membrane over the protective plug 2. remove the cover foil
3. press on the sleeve without bubbles.
